Skip to content

10 years of experience, licensed and insured. Free estimates: (972) 325-2877

(972) 325-2877

ServicesCommercial Roofing

Commercial Roofing in Murphy, TX

We install low-slope and metal roof systems on shops, offices and small commercial buildings. Most leaks on a flat roof start at a seam, a drain or a pipe boot. Those are the spots we slow down on, so your roof stays dry and your business keeps running.

Roofer kneeling on a white membrane flat roof of a brick commercial building, driving a fastener near a vent stack, with a membrane roll and rooftop HVAC unit

What commercial roofing means for your building

A commercial roof is a different animal from a sloped shingle roof. Water does not run off fast. It sits, it finds the weak spot, and it gets in. So the roof is only as good as its seams, edges and penetrations.

We put down TPO, modified bitumen and metal roof systems on retail spaces, offices, warehouses and small strip centers in Murphy and nearby towns like Wylie, Plano and Allen. We have 10 years of experience, and most of what we have learned comes down to small details done the same careful way every time.

If you own a house instead, our Residential Roofing page covers that work. For build-outs or other work on the building itself, see Commercial Contracting.

What the work includes

Membrane or metal, matched to the building
We walk the roof and talk through which system fits your slope, budget and how you use the space. TPO handles summer heat well. Modified bitumen takes foot traffic. Metal suits buildings with some pitch.
Insulation and cover board
We lay insulation and cover board under the membrane where the system calls for it. Tapered insulation can move water toward the drains instead of letting it pond.
Heat-welded and probed seams
On TPO, we weld every seam with hot air and check it with a probe the same day. A seam that looks fine but is not fully fused is where trouble starts.
Flashing at curbs and pipes
HVAC curbs, vent pipes and skylights get their own flashing, cut and fit by hand. This is slow work, and it is where we spend the extra time.
Edge metal and drains
We set edge metal and termination bar so wind cannot peel the membrane back. Roof drains and scuppers get new clamping rings or flashing so water leaves the roof cleanly.
Cleanup each day
Scrap goes off the roof and into a dumpster as we go. We run a magnet over the lot and walkways so loose fasteners do not end up in tires.

Signs your building needs a new roof system

  • Water that sits for days

    Ponding that hangs around two days after rain wears the membrane down fast. It usually means the roof has sagged or the drains are not doing their job.

  • Seams pulling apart

    Lifted edges on seams or laps let water under the membrane. Once it gets in, it soaks the insulation below.

  • Blisters and soft spots

    Bubbles in the surface or spots that give underfoot often mean trapped moisture. Wet insulation does not dry out on its own.

  • Stains on ceiling tiles

    Brown rings on drop ceilings show water has made it all the way through. By then the problem on top is usually bigger than the stain.

  • Patches on top of patches

    If the roof is a quilt of old fixes, it may be time to stop chasing leaks and start fresh.

How a commercial roofing job runs

  1. 1

    Free estimate on the roof

    We go up, measure, take photos and core a small sample if we need to see what is under the membrane. You get a written estimate broken out line by line.

  2. 2

    Planning around your business

    We set work hours with you so customers and staff can still get in. We pull the permit where the city requires one and plan where the dumpster and crane go.

  3. 3

    Tear-off and dry-in by section

    We strip the roof a piece at a time, sized to what the crew can cover with new material before quitting time. The building is sealed up every night, so a surprise rain stays outside.

  4. 4

    Details and final walk

    Flashing, edge metal and drains get finished last, then we walk the roof with you. You see the seams, the curbs and the drains before we call it done.

Roofer kneeling on a white flat membrane roof, checking seams by hand near vent stacks and a rooftop HVAC unit, with a tool bag and strip mall beyond

What sets the price of a commercial roof

No two commercial roofs cost the same. We list each part of the job on its own line in your written estimate, so you can see where every dollar goes. These are the things that shift the total most.

How big the roof is and how it's laid out
More square footage means more material. Layout counts too: parapets, inside corners and changes in level slow the crew down compared with one wide, open flat section.
Rooftop equipment and openings
Every HVAC curb, vent pipe and skylight gets flashing that is cut and fitted by hand. The more of them a roof has, the more labor it takes.
Condition below the existing membrane
Soaked insulation or a rusted deck has to be removed and replaced. If we find either, we send you photos and talk it over before doing any added work.
Roof system, access and permits
TPO, modified bitumen and metal each carry their own price. A cramped lot, a tall building or the need for a crane raises staging costs, and permit fees are added on top.

Commercial roofing questions we get

Something not covered here? (972) 325-2877

Does our business have to shut down during the work?

In most cases, no. We try to put the noisiest work in your quieter hours and keep walkways clear. Before we start, we review the plan with you so your staff knows what's coming.

Do you handle commercial roofing work?

We do, and we are licensed and insured. Bring it up when you call and we'll go over the details with you.

Which roof system is best for a flat roof?

It depends on your building. TPO bounces heat away and welds into tight seams, which makes it a good match for many North Texas buildings. Modified bitumen holds up better where people walk on the roof often. We explain the tradeoffs and you make the call.

How long does the job take?

A small building is usually done in a few working days. Bigger roofs, wet insulation uncovered during tear-off or rainy weather can add time. Your estimate includes a schedule, and we tell you right away if it shifts.

Do you work outside Murphy?

Yes. Along with Murphy, we roof commercial buildings in surrounding towns like Sachse, Garland, Richardson and Rowlett. Our Service Areas page has the complete list.

Flat commercial roof with dark membrane, rooftop HVAC unit, vents and a drain near the parapet, with a strip of shops and trees in the background

Get the details right on your next roof

Tell us about your building and we will come out, get on the roof and give you a written estimate at no cost.