ServicesResidential Roofing
Residential Roofing in Murphy, TX
We put new roofs on homes and we sweat the small parts. Straight starter rows, nails in the right spot, flashing that sheds water. Those details are what keep a roof tight for years. Call us and we will come out and give you a free estimate.

A roof is only as good as how it goes on
Most roofs don't fail in the middle of a shingle field. They fail at the edges, the valleys, the walls and the pipes. That is where a rushed crew cuts corners, and it is where we slow down.
We are licensed and insured, with 10 years of experience putting roofs on homes. We tear off down to the decking, fix what's bad underneath, and build the new roof back up layer by layer. You see what we find before we cover it.
It's the right call when your roof is near the end of its life, has failed in more than one spot, or is losing granules faster than it should. North Texas sun and spring hail wear shingles out hard, so a solid install matters here.
What goes into one of our roofs
- Strip down to bare wood
- Every old shingle and every scrap of felt comes off so the decking is in plain view. Any boards that are soft or rotted get swapped out before new material goes on.
- Drip edge and starter strip
- Metal drip edge runs along the eaves and rakes so water falls off clean instead of soaking the wood. A starter strip seals down the first course, which is the one wind grabs first.
- Underlayment and valley membrane
- Synthetic underlayment goes over the full deck. In the valleys and low spots we lay a self-adhering membrane, because that's where the most water runs.
- Nails where they belong
- Each shingle gets the full nail count, driven flush inside the marked strip. Nails set high or at an angle are a big reason shingles lift in wind, so we watch every course.
- New flashing at walls, chimneys and pipes
- Old step flashing and cracked pipe boots get thrown out, not reused. These joints account for more leaks than any other part of a roof.
- Balanced attic ventilation
- We match intake at the eaves with exhaust at the ridge so hot air has a way out. An attic that cooks all summer ages shingles from the underside.
When your home is ready for a new roof
Sandy grit washing off after rain
The gritty coating on asphalt shingles wears away with age. If you see piles of it near the downspouts after a storm, the shingles are thinning out.
Shingle edges cupping or splitting
Curled or cracked edges show the shingles have dried out. At that point they no longer seal down, and wind and rain can work underneath.
Water spots in several rooms
One drip may trace back to one weak spot. Stains showing up across different ceilings usually point to a roof that is worn out overall.
A dipping ridge or spongy decking
A sagging roofline, or boards that flex when stepped on, often means water has been getting to the wood for a while.
Shingles nearing two decades
Many houses around Murphy are still on their first or second roof. If yours is getting close to 20 years old, have us come out and give it a look.
What sets the price of your new roof
No two roofs we quote come out the same. Homes with matching footprints can end up far apart once pitch, the number of old layers and the condition of the boards underneath are counted. Your written estimate breaks out each item rather than giving one lump sum.
How big and steep the roof is
More roof means more material and more labor. On a steep roof the crew works tied off from roof jacks, so every row takes longer to set.
How many old layers come off
Some houses have a second roof laid over the original. Stripping both adds time and extra loads of debris to the dump.
The decking below
Plywood that is soft or coming apart gets cut out and replaced. The number of sheets isn't known until the old roof is off, so your estimate lists a set price per sheet in advance.
Which shingle line you pick
Standard architectural shingles cost the least. Impact-rated and premium designer lines run higher, and we'll explain what the extra money buys you.
Angles, valleys and openings
Every valley, dormer, skylight and chimney needs flashing measured and fitted by hand. A roof with lots of cuts takes more labor than a simple two-sided gable.
How the job runs
- 1
Free estimate at your home
We look over the roof and the attic, snap photos and go through what we found with you. Then you get a written estimate with each piece of work listed separately.
- 2
Permit and materials
We handle the permit where the city requires one and order the shingles, flashing and vents. We pick a start date together and call you if weather pushes it.
- 3
Tear-off and decking
Tarps go over your beds and shrubs first, then the old roof comes off. If any decking is bad, you see it before we replace it.
- 4
Building the new roof
Drip edge, underlayment, shingles, flashing and vents go down in that order. Most homes wrap up in a day or two.
- 5
Cleanup and final walk
We sweep the lawn, beds and driveway with rolling magnets to catch stray nails, and every bit of old roofing leaves with us. Last, we go over the finished roof with you.

Residential roofing questions
How long will the work take?
A typical home takes one or two days. Big or steep roofs can run a bit longer. When rain is on the way, we wait instead of leaving your roof open to it.
Can the new shingles just go on top of the old ones?
It can be done, but we don't recommend it. A second layer covers up the decking, traps heat against the new shingles and keeps them from lying flat. Stripping the old roof lets us repair the wood and put in fresh flashing the right way.
Will I get a say in the shingle color and style?
Yes. We bring samples out so you can hold them up against your brick or siding in daylight. We'll point out which lines stand up better to hail and heat, and the choice is yours.
What if you find rotten wood once the old roof is off?
We pause and show you in person, or text you photos if you're not home. Since the per-sheet price is already on your estimate, you know the cost before any board gets swapped.
Do I need to be home during the job?
You don't, though a short chat when we start and a walk-around when we finish helps. Please park cars off the driveway. Hammering carries indoors, so it's smart to take framed photos down from upstairs walls.
Do you work outside Murphy?
We do. Besides Murphy, our crews put roofs on homes in Wylie, Sachse, Parker, Plano and several neighboring towns. Each one is named on our Service Areas page.

Let's look at your roof
We'll come out, check the roof and attic, and tell you straight what it needs. The estimate is free and it's written out line by line.